Our Online Store have the new products: RFID antenna board. Currently it can work with
JC10M24R and
JCOP4 card chips.
Compared with normal cards, the antenna board module has a smaller size and fixed holes, which is easy to integrate in the IOT(Internet Of Things) project.
Find answers to most frequently asked questions when shopping.
-
Squli
- Posts: 13
- Joined: Wed Sep 14, 2016 4:06 am
- Points :156
-
Contact:
Post
by Squli » Sat Sep 17, 2016 11:49 pm
I am considering to buy some A22CR cards. And I want my cards to have the following configuration: Both T=0 and T=1, Type B, mifare 1k, ECC.
Just to confirm, is this configuration ok?
-
Danieken
- Posts: 19
- Joined: Thu Sep 17, 2015 10:28 pm
- Points :101
-
Contact:
Post
by Danieken » Sun Sep 18, 2016 5:16 am
AFAIK, for A22CR card, it can not support Type B and mifare 1k at the same time.
-
JavaCardOS
- Posts: 273
- Joined: Thu Apr 30, 2015 12:00 pm
- Points :2405
-
Contact:
Post
by JavaCardOS » Sun Sep 18, 2016 5:50 am
As A22CR cards can not support Type B and Mifare interface simultaneously, you can only choose one of them. Other requirements are ok.
So please re-confirm your card requirement.
Users browsing this forum: No registered users and 38 guests
JavaCard OS : Disclaimer
Board Disclaimer
The views and comments posted in these fora are personal and do not necessarily represent the those of the Management of JavaCard OS.
The Management of JavaCard OS does not, under any circumstances whatsoever, accept any responsibility for any advice, or recommentations, made by, or implied by, any member or guest vistor of JavaCard OS that results in any loss whatsoever in any manner to a member of JavaCard OS, or to any other person.
Furthermore, the Management of JavaCard OS is not, and cannot be, responsible for the content of any other Internet site(s) that have been linked to from JavaCard OS.
