Our Online Store have the new products: RFID antenna board. Currently it can work with
JC10M24R and
JCOP4 card chips.
Compared with normal cards, the antenna board module has a smaller size and fixed holes, which is easy to integrate in the IOT(Internet Of Things) project.
Other Tools
-
ToneLoc
- Posts: 4
- Joined: Mon Dec 06, 2021 3:59 am
- Points :80
-
Contact:
Post
by ToneLoc » Mon Dec 06, 2021 6:35 pm
I am trying to initialize a J2A040 I have a mcr200 and for some reason my
pyApdutool or pyresman programs won't recognize my card reader. I have the drivers installed that came with my reader but they only work with the shitty programs that came with the mcr200 which are mostly in Chinese. so I'm just lost and pissed. I bought jcopengliah and jcophirolive but I can't seem to get them to write any actual commands. all I got from them was a blank command line screen and this error message. hopefully someone here can help me I'm at my wits end
-
patos
- Posts: 1
- Joined: Sun Dec 19, 2021 10:41 pm
- Points :26
-
Contact:
Post
by patos » Sun Dec 19, 2021 10:45 pm
Did you get a solution bro? I have exactly the same problem.
Users browsing this forum: No registered users and 2 guests
JavaCard OS : Disclaimer
Board Disclaimer
The views and comments posted in these fora are personal and do not necessarily represent the those of the Management of JavaCard OS.
The Management of JavaCard OS does not, under any circumstances whatsoever, accept any responsibility for any advice, or recommentations, made by, or implied by, any member or guest vistor of JavaCard OS that results in any loss whatsoever in any manner to a member of JavaCard OS, or to any other person.
Furthermore, the Management of JavaCard OS is not, and cannot be, responsible for the content of any other Internet site(s) that have been linked to from JavaCard OS.