JavacardOS will not accept order any more, please contact our partner Feitian online Store:
https://ftsafe.en.alibaba.com/index.html
https://ftsafe.en.alibaba.com/index.html
J3D081 pre-personalize as T1 card
J3D081 pre-personalize as T1 card
Unfortunately, the J3D081 cards that I have obtained for a hobbyist project are pre-personalized. The vendor is far away overseas (e.g. China) and is of no help.
I would like to set them up for ISO 7816 transport protocol type T=1. My documentation I have available from my University time is for the J3A081 that uses different addresses. So currently I am only able to boot the root applet using the TK. The Javacard is not protected nor fused. However, writing to the memory addresses gets blocked and I receive RET: 69 84. Obviously, as I am targeting the wrong addresses that are only valid for J3A081.
Am I out of luck or is there a way to get the required APDU codes? I know the required documentation (e.g. Admin Manual) is encumbered by NDA that should maintain the security of the protected area of the smartcard.
What would happen, when I send the command to boot the root applet (e.g. reset to defaults) and immediately send the fuse command? I would think the card would be lost as the defaults do not match the settings for any transport protocol to talk to the card using Global Platform.
Is there hope for me or are the cards not useable? Thanks in advance for your help!
I would like to set them up for ISO 7816 transport protocol type T=1. My documentation I have available from my University time is for the J3A081 that uses different addresses. So currently I am only able to boot the root applet using the TK. The Javacard is not protected nor fused. However, writing to the memory addresses gets blocked and I receive RET: 69 84. Obviously, as I am targeting the wrong addresses that are only valid for J3A081.
Am I out of luck or is there a way to get the required APDU codes? I know the required documentation (e.g. Admin Manual) is encumbered by NDA that should maintain the security of the protected area of the smartcard.
What would happen, when I send the command to boot the root applet (e.g. reset to defaults) and immediately send the fuse command? I would think the card would be lost as the defaults do not match the settings for any transport protocol to talk to the card using Global Platform.
Is there hope for me or are the cards not useable? Thanks in advance for your help!
Re: J3D081 pre-personalize as T1 card
Hi, I'm having the same issue with J3D081 cards, were you able to solve it?
Re: J3D081 pre-personalize as T1 card
Hey, I'm also stuck at this problem, did anybody solve it?
Who is online
Users browsing this forum: No registered users and 1 guest