Page 1 of 1

How to perform GetData command using Feitian R502 reader with a DESFire EV1 card?

Posted: Wed Jan 04, 2017 11:03 pm
by marclo
How do I perform the ISO7816 GetData command using the Feitian R502 reader with a DESFire EV1 card?
I send the APDU as documented by yourselves 0xFF 0xCA 0x00 0x00 0x00 but I dont get the response back that I would expect, 7 bytes + status. Instead I get status error 0x6e.
Any help you can give on this would be much appreciated.

Re: How to perform GetData command using Feitian R502 reader with a DESFire EV1 card?

Posted: Thu Jan 05, 2017 1:45 am
by Hooben
Thanks for your feedback.
The issue is exist issue, our implement is according with ISO 14443 and PC/SC standard, our engineer did check only logic memory card can support this command.

Anyway, since we got some requests from other customer also, then we do modify our firmware to make it support, you can through our update tool to have 3.50 firmware and that support get UID command, any questions, contact us anytime, thanks

Update tool can found from below: https://github.com/FeitianSmartcardReader/R502/tree/master/Tools/R502.Update

Re: How to perform GetData command using Feitian R502 reader with a DESFire EV1 card?

Posted: Thu Jan 05, 2017 9:56 pm
by marclo
Hooben wrote:Thanks for your feedback.
The issue is exist issue, our implement is according with ISO 14443 and PC/SC standard, our engineer did check only logic memory card can support this command.

Anyway, since we got some requests from other customer also, then we do modify our firmware to make it support, you can through our update tool to have 3.50 firmware and that support get UID command, any questions, contact us anytime, thanks

Update tool can found from below: https://github.com/FeitianSmartcardReader/R502/tree/master/Tools/R502.Update


Thanks for your answer. I will have a try.
If there is still any problem, I will come back to you.